JVC RM-G860E Bedienungsanleitung Seite 7

@ Player B indicator
Lights when player B is selected with the A/B buttons on
the Editing Control Section.
LAP indicator for player B
Lights when the Lap mode is selected with the LAP button
@.
LAP button for player B
With this button ON, the elapsed time is displayed from the
edit-in point of either the current edit (if already entered) or
the previous edit. The LAP indicator lights while the elapsed
time is being displayed.
RESET button for player B
When the time counter is in the CTL mode, counter data, lap
time and entered edit data can all be cancelled by pressing
this button. In the TC mode, lap time and entered edit data
can be cancelled.
IN/OUT indicators for player B
"IN" lights or blinks when edit-in point data is displayed and
"OUT" lights or blinks when edit-out point data is displayed.
SERVO lock indicator for player B
Lights when the VTR's drum servo and capstan servo
systems are locked.
Counter display for player B
Indicates tape position and edit data, etc. in hours,
minutes, seconds and frames for the VTR connected to the
PLAYER B connector on the rear panel (9-pin or 45-pin).
Also displays error messages.
LAP indicator for recorder
Lights when the Lap mode is selected with the LAP button
LAP button for recorder
With this button ON, the elapsed time is displayed from the
edit-in point of either the current edit (if already entered) or
the previous edit. The LAP indicator lights while the elapsed
time is being displayed.
RESET button for recorder
When the time counter is in the CTL mode, counter data, lap
time and entered edit data can all be cancelled by pressing
this button. In the TC mode, lap time and entered edit data
can be cancelled.
IN/OUT indicators for recorder
"IN" lights or blinks when edit-in point data is displayed and
"OUT" lights or blinks when edit-out point data is displayed.
SERVO lock indicator for recorder
Lights when the VTR's drum servo and capstan servo
systems are locked.
@ TOTAL button
When this button is pressed, the total time of executed
edits from the initial time is displayed on the recorder's
counter display. When the TOTAL button and the IN button
for the recorder are pressed simultaneously, the initial time
is indicated. When the TOTAL and GOTO buttons are
pressed simultaneously, the tape position corresponding to
the initial time is accessed. Also, when the RESET button
for the recorder and the TOTAL button are pressed
simultaneously, the total time is reset. If no edit-in point is
entered and the total time is not reset after setting the
POWER switch to ON, the initial time will be the point where
the TOTAL button is first pressed. If an edit-in point is
entered before pressing the TOTAL button, the initial time
will correspond to the edit-in point.
Counter display for recorder
Indicates tape position and edit data, etc. in hours,
minutes, seconds and frames for the VTR connected to the
RECORDER connector on the rear panel (9-pin or 45-pin).
Also displays error messages.