JVC RM-G860E Bedienungsanleitung Seite 5

Simplified Auto Tracking editing
AT (Auto Tracking) playback is possible when VTRs equipped with Auto Tracking (AT) heads
are used and controlled via the 9-pin connectors. Tape speed can be varied within the range
permitted by the AT VTR. The RM-G860E registers the adjusted AT playback speed and
' controls the VTR at this exact speed in actual editing.
_ Audio-split editing
Audio edit-in points can be specified independently of video edit-in points. Entry points are
determined in frames relative to the video edit-in points.
Time counter memory
In addition to edit-in and edit-out points, up to four counter readings can be temporarily held in
memory. The stored counter data can be checked at any time by pressing the corresponding
DA button, located by pressing the GOTO button, or transferred as edit-in or edit-out points.
Trimming function with recorder's jog dial
Edit duration, edit-in and edit-out points, audio edit-in point, and GPI pulse timing from the
video switcher and audio mixer ports can all be set directly with the jog dial for the recorder.
Capstan bump function
The capstan bump function keeps the three VTRs in phase, ensuring high editing accuracy.
Preview, review and go-to functions
Preview, review and go-to functions are provided. The go-to function permits location both of
edit points and of memorized counter reading points. Edit-in or edit-out points on all three
VTRs can also be located with a single operation. In cut editing, in addition to normal preview,
an edit-out preview function is available for confirmation of only the section across the edit-out
point.
Error messages
Warnings are available as error messages on the time counter display.
Last-edit display
Edit-point data for the previous edit can be displayed on the time counters.