Werbung
Verfügbare Sprachen
Verfügbare Sprachen
EDITING CONTROL UNIT RM-G860E
OUT
SERVO
MIN
SEC
FRAME
cicada
] we
Wrest
o
a,
a]
ee
oe ot
gaa
OUT
SERVO
Sec
ae
"OUT SERVO es]
SEC
FRAME
PELE og Gao
Editing Control Section
®
®
SPLIT indicators
The corresponding indicator lights when an audio edit-in
point is entered in audio-split editing. See page 33.
DA buttons (DA1 to DA4)
Press
to temporarily
store
time counter
readings
in
memory. The stored time counter readings can be called up
and used as edit points. Effective only for the players. See
page 37.
Be careful; if DIP switch SW2-1
is set ON, time counter
readings are not stored in memory.
A/B roll select buttons
To specify the order of playback between two playback
VTRs in AVB roll editing.
A-B:
Player A starts playback first, followed
by
player B.
BA:
Player B starts playback first, followed by
player A.
If the order of playback is not selected, editing
can be done between the player selected with
the A/B select buttons @ and the recorder.
Player A/B select buttons
To select the player to be controlled via the player control
section.
A button (A/AUX)
A:
To select player A.
@
AUX (SHIFT+A):
(Press together with the SHIFT button
@.) The VTR used as the recorder can
be used to edit from external sources,
independently
from
the
players
connected to the RM-G860E.
B button (B/BOTH)
B:
To select player B.
BOTH (SHIFT+B):
(Press together with the SHIFT button
@.) Used to conirol players A and B
simultaneously.
Edit mode select buttons
To select either the Assemble or Insert Edit mode and the
signal(s) to be inserted (video, audio-1, audio-2, time
code). Set these buttons before starting preview editing or
actual editing.
ASSEM:
To assemble-edit the video, audio-1, audio-2,
and time code (if available) signals.
AUD-1:
To insert-edit the audio-1 signal.
AUD-2:
To insert-edit the audio-2 signal.
VIDEO: _ To insert-edit the video signal.
These three insert buttons can be used in any combination
by pressing them ON. The LEDs above the AUD-1 and AUD-
2 buttons light when the corresponding signal is assigned
for split-editing.
(TC):
The user bits are displayed on the time counter
while this button is being depressed. When
pressed together with the SHIFT button @, the
time code will be inserted.
Werbung
