Werbung
Verfügbare Sprachen
Verfügbare Sprachen
PREPARATION
Prepare VTRs as players and recorder as follows:
select switch, Video/Audio signal recording level, etc. Set
the FRAME SERVO switch to COLOUR FRAME.)
In 9-pin editing, the colour framing mode can be selected. Two
DIP switches are provided for colour framing mode selection:
one on the system setting pane! and one on the rear panel.
Initial settings of these switches are for the 4-field sequence
mode.
-
switch SW2-5 to ON.
Prepare the RM-G860E system setting panel as
To select the 8-field mode, set rear panel DIP switch SW4-3
follows:
to ON.
2. Set the 45/9 (45-pin/9-pin) switches according to the VTRs
Other DIP switches
8. Confirm the other DIP switch settings and change as
required. See pages 11 and 12.
3. Set the TC/CTL switches according to the reference signal
used by each VTR's time counter. Normally set to TC; set to
CTL, if 45-pin is selected or time codes are not to be used
with 9-pin selected. When the switch is set to TC, the user
(Anpoeessl hl om
bits can be checked during playback by pressing the button
{ ee
8
with TC on its front.
i
ffonnnenal?
CTL
4. Set the BUMP switch to ON or OFF.
When set to ON, check DIP switch SW1-1 setting.
BUMP
Bi.
OFF
5. Set the PREROLL switch as required. When the preroll time
is set to 10 seconds, it can be modified to 15 seconds using
DIP switch SW1-5.
12345678
Te
——OFF——
12345678
TEC
SW.3
SW.4
PREROLL
0
7
5
~17-
Werbung
