JVC RM-G860E Bedienungsanleitung Seite 6

CONTROLS AND CONNECTORS
FRONT PANEL
Display Section
7
Agee
a8
Ble!
Ben
ele
RECORDER
@ POWER switch
Turns the power of the RM-G860E ON and OFF. Before
turning the power ON, make sure all external equipment has
been connected.
PLAYER-A EJECT button
PLAYER-B EJECT button
Press to eject the video cassettes from the VTRs
connected to the PLAYER connectors on the rear panel (9-
pin or 45-pin).
@ RECORDER EJECT button
Press to eject the video cassette from the VTR connected
to the RECORDER connector on the rear panel.
Display Section
@ Player A indicator
Lights when player A is selected with the A/B buttons on
the Editing Control Section.
@ LAP indicator for player A
Lights when the Lap mode is selected with the LAP button
o.
@ LAP button for player A
With this button ON, the elapsed time is displayed from the
edit-in point of either the current edit (if already entered) or
the previous edit. The LAP indicator lights while the elapsed
time is being displayed.
© RESET button for player A
When the time counter is in the CTL mode, counter data, lap
time and entered edit data can all be cancelled by pressing
this button. In the TC mode, lap time and entered edit data
can be cancelled.
© IN/OUT indicators for player A
"IN" lights or blinks when edit-in point data is displayed and
"OUT" lights or blinks when edit-out point data is displayed.
@ SERVO lock indicator for player A
Lights when the VTR's drum servo and capstan servo
systems are locked.
@ Counter display for player A
Indicates tape position and edit data, etc. in hours,
minutes, seconds and frames for the VTR connected to the
PLAYER A connector on the rear panel (9-pin or 45-pin).
Also displays error messages.