Herunterladen Diese Seite drucken

Parkside PDU 300 A1 Bedienungs- Und Sicherheitshinweise Seite 23

Werbung

Verfügbare Sprachen
  • DE

Verfügbare Sprachen

  • DEUTSCH, seite 25
16. Troubleshooting
Fault
Engine does not start
Motor runs erratically
Motor is overheated
The machine does not move
when the engine is running
16
GB/IE
Possible cause
Spark plug connector unplugged.
Contaminated spark plug.
No fuel or old fuel.
Choke not in open position.
Fuel line clogged.
Engine flooded.
Spark plug connector loose.
Engine running in choke position.
Fuel line clogged or old fuel.
Ventilation blocked
Water or contamination in the fuel system
Incorrect carburettor setting
Engine oil level low.
Contaminated air filter.
Airflow restricted.
Carburettor not adjusted correctly.
The gear was not chosen correctly.
Remedy
Re-connect the spark plug cable to the spark plug.
Clean, set gap or replace.
Fill with clean, fresh petrol.
The choke lever must be positioned in the choke position
during cold starting.
Check the fuel line for kinks or damage.
Wait a few minutes before restarting.
Connect and fasten the spark plug cable.
Set the choker-arm to OFF.
Fill the tank with clean, fresh petrol.
Clean the air filter.
Empty the tank. Fill the tank with fresh fuel.
Contact the service department.
Top up the oil.
Clean or replace the air filter.
Remove and clean the housing.
Contact the service department.
Shift the shift lever to the correct shift position.

Werbung

loading