Intended Use - Bosch EPS 118 Originalbetriebsanleitung

en 50 | EPS 118 | Important notes
2. Important notes
Before start up, connecting and operating
Bosch products it is absolutely essential
that the operating instructions/owner's
manual and, in particular, the safety in-
structions are studied carefully. By doing so you can
eliminate any uncertainties in handling Bosch products
and thus associated safety risks upfront; something
which is in the interests of your own safety and will
ultimately help avoid damage to the device. When a
Bosch product is handed over to another person, not
only the operating instructions but also the safety
instructions and information on its designated use must
be handed over to the person.
2.1

Intended use

The EPS 118 with its accessories is intended solely for
the testing of Bosch passenger car common rail injec-
tors with solenoid valve (CRI) with coil resistance up to
5 ohms and passenger car common rail injectors with
a piezo valve (piezo CRI) and commercial vehicle com-
mon rail injectors (CRIN). for non-Bosch injectors (Del-
phi, Denso and Siemens/VDO/Conti), special connect-
ing cables and hose assemblies (optional accessories)
are required. For commercial vehicle common rail injec-
tors, special test adapters or return adapters (optional
accessories) are required.
The EPS 118 provides an automatic test sequence to
determine whether the tested injector can continue to
be used.
The accessories and supplementary equipment sets
listed, as well as all replacement and wearing parts are
only to be used in conjunction with EPS 118. Any other
use above and beyond this is considered improper. The
manufacturer/supplier will not be liable for any damage
resulting from such use. The user bears the sole risk.
Additional important notes:
R
Gasoline injection cannot be tested with the
EPS 118.
R
The high-pressure hose assembly is only to be
used under the guard when testing CRI, CRIN and
piezo CRI.
R
Hose assemblies and adapter cables are not to be
extended or altered.
R
The guard contact is not to be jumpered.
R
Only use genuine spare parts.
|
1 689 989 300 2018-05-24
!
CRI and CRIN measurements on the EPS 118 do not
qualify for warranty entitlement.
i
The current test procedures and set values for the
various Bosch injectors are contained on the "Test-
Data USB / Bosch Web Server".
i
EPS 118 is not designed for long-term testing.
Rule
¶
Operating instructions and safety instructions must
be kept close to hand at the service location.
¶
All safety instructions and hazard information on the
EPS 118 are to be observed and kept in a legible
condition.
¶
Rectify any faults immediately which may impair safety!
¶
If changes occur that affect safety, immediately turn
off the EPS 118 and notify the responsible depart-
ment or individual.
¶
If the operating behavior changes, immediately turn
off the EPS 118 and notify the responsible depart-
ment or individual of the problem.
¶
EPS 118 and all products and the accessories
required for testing within their specified operating
ranges only.
¶
Only test injectors using the test equipment stipulat-
ed by the manufacturer. In the case of test equipment
that does not originate from Automotive Aftermarket,
the safety regulations of the respective manufacturer
must always be observed. Nonobservance can endan-
ger the operator and test specimen.
¶
In case of non-use, disconnect the EPS 118 from
the mains voltage system.
¶
Observe the intervals specified or given in the oper-
ating instructions for routine checks/maintenance.
¶
Have Bosch Customer Service check the unit ev-
ery 2 years to ensure adjustment accuracy (e. g. to
ISO 9000).
Robert Bosch GmbH