Appendix; Description Of The Data Blocks Used In The S3000 - SICK S3000 Expert Bedienungsanleitung

12

Appendix

Note
Block description
Data block name
Operating data block
90
© SICK AG • Industrial Safety Systems • Germany • All rights reserved
This appendix lists the data blocks that are relevant for using the measurement data of
the S3000 expert (section 12.1) and S300 expert (section 12.2).
All data listed in this appendix are volatile, i. e. they are not maintained through power
down.
Only for Compatibility mode: In this appendix, the term Control Area A refers to the active
field set, while Control Area B refers to the active simultaneous field set. The term
Monitoring Area refers to the configured field sets 0 ... (n – 1). Each field set may consist
of one protective field and one or two warning fields. For details on field sets, see the
operating instructions of the S3000/S300.

12.1 Description of the data blocks used in the S3000

12.1.1 Operating data block (block no. 11)
Block no.
11
Block registers Block words
Operating mode 0
Display data 1 ... 2
Input data 3 ... 4
Output data 5
Monitoring data 6
Configuration counter 7
Device time-on 8 ... 9
Reserved for internal 10 ... 81
use
Register description
Register name Block word
Operating mode 0
Block size External access
164 Byte Read only
Register size Register description
2 Byte Operating mode of device
4 Byte Actual display contents
4 Byte Input data
2 Byte Output data
2 Byte Monitoring data
2 Byte Configuration counter info
4 Byte Device time-on since last power-up
132 Byte Reserved
Field bits Field name
0 ... 3 Device state
4 Device mode
5 ... 7 n/u
Telegram Listing CMS
S3000/S300 Expert
Field description
0: Normal
1: Configuration
2: Lockout
3: System initialization
4: Wait for valid inputs
5: Front screen calibration
6: Boot
7: Production
8: Wait for reset
9: Teach-in
Other: n/u
0: Device is in regular
mode
1: n/u
n/u
8015791/WS20/2012-12-12
Subject to change without notice