F-Parameters - TR-Electronic CDV582M 8192/65536 EPN 50ZB12NT + FS2 Gesamt-Bedienungsanleitung

3.2 F-Parameters

Except for
meaningful values in the defaultsetting and should only be changed if expressly
requested by the automation function. For safe transmission of the individually set
F-Parameters
TIA Portal V14. This checksum corresponds to the F-Parameter F_Par_CRC,
which is displayed in the device view in the inspector window under Properties
-> General -> PROFIsafe during configuration of the measuring system. Also see
the chapter "Setting the F-Parameters" on page 103.
Printed in the Federal Republic of Germany
12/17/2020
the F-Parameters are already preconfigured with
F_Dest_Add
a CRC is required,
TR - ECE - TI - DGB - 0340 - 01
which is calculated
 TR-Electronic GmbH 2019, All Rights Reserved
automatically by
Page 85 of 144