Obligation Of Workshop Operator - Bosch ACS 511 Originalbetriebsanleitung

Liability
All data in this program is based - where possible - on
manufacturer and importer details. Bosch does not ac-
cept liability for the correctness and completeness of
software and data; liability for damage caused by faulty
software and data is ruled out. Whatever the event,
Bosch liability is restricted to the amount for which the
customer actually pays for this product. This disclaimer
of liability does not apply to damages caused by intent
or gross negligence on the part of Bosch.
Warranty
Any use of non-approved hardware and software will
result in a modification to our product and thus to exclu-
sion of any liability and warranty, even if the hardware or
software has in the meantime been removed or deleted.
No changes may be made to our products. Our products
may only be used in combination with original acces-
sories and original service parts. Failing to do so, will
render null and void all warranty claims.
This product may only be operated using Bosch ap-
proved operating systems. If the product is operated
using an operating system other than the approved one,
then our warranty obligation pursuant to our supply
conditions will be rendered null and void. Furthermore,
we will not be held liable for damage and consequential
damage incurred through the use of a non-approved
operating system.
2.3

Obligation of workshop operator

The workshop operator is obliged to ensure that all
measures geared towards the prevention of accidents,
industrial diseases, labor-related health risks are taken
and measures towards making the workplace fit for
people to work in are carried out.
Electrical engineering in Germany is subject to the
accident prevention regulations of the trade associa-
tion "Electrical Plant and Equipment as under DGUV
Vorschrift 3 (previously BGV A3)". In all other countries,
the applicable national regulations acts or decrees are
to be adhered to.
Robert Bosch GmbH
Symbols used | ACS 511 | 37
Basic rules
The workshop operator is bound to ensure that all
electrical equipment and operating material is set up,
modified and maintained by skilled electricians only
or under the guidance and supervision of a skilled
electrician in accordance with electrical engineering
principles.
Furthermore, the workshop operator must ensure that
all electrical equipment and operating material is oper-
ated in keeping with electrical engineering principles.
If a piece of electrical equipment or operating material
is found to be defective, i.e. it does not or no longer
complies with electrical engineering principles, the
workshop operator must ensure that the fault is recti-
fied immediately and, in the event that imminent danger
exists, also ensure that the electrical equipment or the
electrical operating material is not used.
Tests (taking Germany as an example):
R
The workshop operator must ensure that all electri-
cal systems and equipment are tested by a qualified
electrician or under the guidance of a qualified elec-
trician to ensure they are in proper working order:
$
Before starting for the first time.
$
After modification or repair before starting for the
first time.
$
At given intervals. Set intervals such as to ensure
that faults that can be expected to occur are de-
termined in good time.
R
The test is to take the electrical engineering prin-
ciples relating hereto into account.
R
Upon request of the trade association, a test manual
is to be maintained into which specific entries are
made.
en
|
S P00 D00 001 2019-02-21