Stand-By Mode - Philips PS6000 Benutzerhandbuch

PS-Micro control desk LBB 6105/00
3.

STAND-BY MODE

In 'STAND-BY' mode (normal operational mode) the control desk monitors all operational PS-
mobiles made 'active' in the system. Each participants PS-mobile is assigned a MOBILE-ID
corresponding to its channel (max. 15 per control desk), shown on the display of the desk above
the corresponding channel button (B1 to B5).The date and time are shown on the upper line at
the right hand side of the display.
3.1 Mobile Identification (MOBILE-ID)
Depending on how your system has been installed, a PS-mobiles identification address (Mobile-
ID) can consist of up to 7 alphanumeric characters (max.) for example - the first name of the
holder, or the holders function within your organisation.The factory default setting is MOB 01 to
MOB 15.The table below gives an example of valid Mobile-IDs.The Mobile-Address shown
below is a 4-digit number programmed in the PS-mobile.
Example of valid
MOBILE-IDs.
NOTE: Throughout
this document the PS-
mobile IDs will be
shown as MOB 01 -
MOB 15 (default).
Desk in 'STAND-BY'
mode showing 5 mobile IDs
(MOB 01 to MOB 05) above
their relevant channel-
buttons. The bi-colour LED
of each active channel is ON
(green).
If more than five channels are
active press the <BM> key
(Fig.1(9)) to manually scroll
to the next set of channels,
or if programmed the display
will scroll automatically after
10 seconds to the next set
of active channels.
NOTE: If not more
than 5-channels are
active, LED (L7) is OFF.
PS-Mobile Mobile-ID
1 0001
2 JOHN
3 GUARD1
4 TECHNIC
5 STORES
MOBILE ID
MOB 01 MOB 02
G G
G
Press to scroll to next set of Mobiles
(max. 15)
MOB 06 MOB 07
G G
G
8
Mobile-Address
0001
0002
0003
0004
0015
Date & Time
28-02-00 16:30
MOB 03 MOB 04
G G
G
28-02-00 16:30
MOB 08 MOB 09
G G
G
User Manual
MOB 05
G
MOB 10
G