Yamaha WR250F Fahrer- Und Wartungshandbuch Seite 204

1 Throttle cable
2 Clamp
3 Brake hose
4 Hot starter cable
5 Clutch cable
6 Hose guide
7 Speed sensor lead
8 Main switch lead
9 Main switch
0 Multi-function display
A Start switch lead
B Clutch switch lead
C Engine stop switch lead
D Multi-function display lead
E-E
A
Ë
D
È Fasten the start switch lead to the han-
dlebar with the plastic bands.
É Fasten the engine stop switch lead and
clutch switch lead to the handlebar with
the plastic bands.
Ê Pass the brake hose through the hose
guides.
Ë Secure the coupler by inserting it into
the multi-function display bracket.
Ì Pass the main switch lead above the
multi-function display bracket.
Í Pass the throttle cables, clutch cable
and hot starter cable between the upper
bracket
bracket.
1
Ó
1
A
0
D
9
Ì 8
Ë
D
7
7
2
Ò
CABLE ROUTING DIAGRAM
and multi-function display
Í
Î
8
A
A
3
2 È
2
E E
E E
2 - 111
SPEC
Î Pass the multi-function display lead and
speed sensor lead between the multi-
function display and multi-function dis-
play bracket.
Ï Secure the coupler by pushing it into
the hole in the multi-function display
bracket.
Ð Fasten the clutch switch lead and
engine stop switch lead to the multi-
function display bracket and cut off the
tie end. Fasten them at a location
where the tie end does not contact the
multi-function display.
Ñ Secure the wire harness clip by pushing
it into the hole in the multi-function dis-
play bracket on the inside.
F
4
4
5
5
F
2 É
B
4
B
B
5
6
Ê
C
Ï B
6 Ê
8
C
F-F
2
C
B
2 Ð
C
Ñ
Ë