Decommissioning; Disassembly And Replacement; Preparing The Product For Storage/Later Use - Bosch Rexroth LU 2/P Montageanleitung

12 Decommissioning

This product is a component which does not need to be decommissioned.
Accordingly, this section has been left blank.

13 Disassembly and replacement

High electrical voltage!
Risk of severe injury or death from electric shock.

Disconnect the relevant system component before performing any maintenance
or repair work.

Secure the system against being unintentionally switched on again.
High hydraulic/pneumatic pressure!
Risk of severe injury or death.

Switch off the hydraulic/compressed air supply to the relevant system
component before performing any maintenance or repair work.

Reduce the residual pressure in the system.

Secure the system against being unintentionally switched on again.
Suspended loads may fall!
Falling objects can result in severe injury (or even death).

Use only slings with suffi ciently high bearing loads (for product weight,
see delivery documents).

Make sure the lifting straps are correctly fastened before lifting the product.

Secure the product against tipping over when lifting!

Make sure that no one but the operator is in the danger zone during lifting and
lowering!

13.1 Preparing the product for storage/later use

• Only set the product down on a fl at surface.
• Protect the product from mechanical stress.
• Protect the product from environmental infl uences, such as dirt and moisture.
• Observe the environmental conditions specifi ed in the technical data,
see page 41.
• For products with a mounted motor: Support the product so that the motor is not
placed under mechanical load.
WARNING
3 842 557 976/2020-08, MIT: LU 2/P-24V-3L, Bosch Rexroth AG
Decommissioning 39/42