Spare Parts; Decommissioning; Disassembly And Replacement; Preparing The Product For Storage/Later Use - Bosch Rexroth LU 2 Montageanleitung

11.4.3

Spare parts

For a list of spare parts, see MTpro
1
) Download from: www.boschrexroth.com/mtpro

12 Decommissioning

This product does not need to be decommissioned. Accordingly, this section has
been left blank.

13 Disassembly and replacement

High electrical voltage!
Risk of serious injury or death from electric shock.

Disconnect the system component requiring maintenance or servicing
before starting.

Secure the system against being unintentionally switched on again.
High pneumatic pressure!
Risk of serious injury or death.

Switch off the compressed air supply to the relevant system component before
performing any maintenance or repair work.

Secure the system against being unintentionally switched on again.
Lifted loads may fall!
Falling objects can result in serious injury (or even death).

Use only slings with suffi ciently high bearing load capacity (for product weight
see shipping documents).

Make sure the lifting straps are correctly fastened before lifting the product.

Secure the product against tipping when lifting.

Make sure that no one but the operator is in the danger zone during lifting
and lowering.

13.1 Preparing the product for storage/later use

• Only set the product down on a fl at surface.
• Protect the product from mechanical stress.
• Protect the product from environmental infl uences, such as dirt and moisture.
• Pay attention to the ambient conditions, see page 53.
• For products with a mounted motor: Support the product so that the motor is not
placed under mechanical load.
Decommissioning
1 ), 3 842 539 057
WARNING
3 842 358 814/2018-12, MIT: LU 2, Bosch Rexroth AG
49/54