Cable Break Detection; Transport And Storage; Transporting The Product; Storing The Product - Bosch Rexroth LU 2 Montageanleitung

26/54

Transport and storage

Bosch Rexroth AG, MIT: LU 2, 3 842 358 814/2018-12
Table 8: Signal states for the outputs OK and Err
Signal output Meaning
OK (Pin 2) Err (Pin 4)
1 0 OK (system in operation)
0 1 Err (error occurred)
0 0
,Err (error occurred),
1 1 LC (oil container empty)
6.8.3

Cable break detection

The lubrication unit monitors the signal outputs OK and Err for cable breaks. If a cable
break is detected by the signal outputs, the plug symbol disappears from the display.
7 Transport and storage
• Follow the transport instructions on the packaging.
• Transport weight: see delivery documents.
• Secure the product to prevent toppling!
• Always maintain ambient conditions during loading and transport, see page 53.

7.1 Transporting the product

Lifted loads may fall!
Falling objects can result in serious injury (or even death).

Use only slings with suffi ciently high bearing load capacity (for product weight
see shipping documents).

Make sure the lifting straps are correctly fastened before lifting the product!

Secure the product against tipping over during lifting!

Make sure that no one but the operator is in the danger zone during lifting
and lowering!

7.2 Storing the product

• Only set the product down on a fl at surface.
• Protect the product from mechanical stress.
• Protect the product from environmental infl uences, such as dirt and moisture.
• Pay attention to the ambient conditions, see page 53.
• For belt sections with mounted motor-gear combination and/or mounted
lubrication unit:
Support the belt section so that the motor-gear combination or lubrication unit
are not overloaded.
Detection of cable break, see page 26
WARNING