Start-Up; Initial Start-Up - Bosch Rexroth LU 2 Montageanleitung

9 Start-up

9.1 Initial start-up

Sudden movements, falling workpiece pallets

Risk of injury caused by sudden movements and falling objects.

Make sure that the product has been installed correctly by qualifi ed personnel
(see page 9) before starting it up.
Malfunctions due to incorrect assembly and start-up
The product can get damaged and its service life shortened.

Start-up requires basic mechanical and electrical knowledge.

The product should only be started up by qualifi ed personnel (see page 9).
Operational malfunctions caused by unequal distribution of the lubricant
The product can be damaged; the service life may be adversely affected.

Only use 2 equal lubricant pins (do not mix adapter sets).
Different lubricating pins cause unequal distribution through an uneven
fl ow resistance.

The difference in length of the lubrication lines should be < 20 mm.
Different lubricating line lengths cause unequal distribution through an uneven
fl ow resistance.
Operational malfunctions due to lack of lubricants
The product can be damaged; the service life may be adversely affected.

Ensure the lubrication lines are completely fi lled with lubricant before the
product is put into operation.
• Before fi rst use or re-commissioning of a conveyor system, run a risk assessment in
accordance with DIN EN ISO 12100.
• Before initial commissioning ensure that there are no protruding or sharp-edged
parts that may endanger personnel working or moving in the area.
• According to EU Machinery Directive 2006/42/EC, you must equip the transfer
system with EMERGENCY STOP devices.
• The surfaces of motors and gears can reach temperatures of over 65 °C under certain
load and operating conditions. In these cases, you must comply with the respective
applicable accident prevention regulations (UVV) by taking appropriate constructive
measures (safety guards) or by affi xing/displaying appropriate warning signs!
CAUTION
NOTICE
3 842 358 814/2018-12, MIT: LU 2, Bosch Rexroth AG
Start-up 41/54