Electrical Connection Of The Product - Bosch Rexroth LU 2/P Montageanleitung

8.5.9

Electrical connection of the product

High electrical voltage!
Risk of severe injury or death from electric shock.

Disconnect the relevant system component before performing any maintenance
or repair work.

Secure the system against being unintentionally switched on again.
Damage to the product caused by faulty electrical connection
The product can be damaged.

Electrical connection requires basic mechanical and electrical knowledge.

The product should only be started up by qualifi ed personnel (see page 9).

The voltage supply must comply with the connection data of the lubrication
unit (see "Technical Data" on page 33). Please also observe the manufacturer
documentation listed in Table 1 on page 6.
Malfunctions if electrical connection is faulty
The product can be damaged.

Do not interchange the connection for the actuators and sensor systems.

Connect the lubrication unit to a protection class II power supply or

ground the lubrication unit separately.
• Choose control and sensor elements in accordance with EN ISO 13849.
• Comply with the standard DIN EN 60204 (previously: VDE regulation VDE 0113)
for Germany, or the corresponding regulations in the country of use.
A A
3
1
Fig. 13: Plug assignment (view of the connector plugs)
Table 7: Plug assignment connector plug A Operating voltage of lubrication unit
Operating voltage of lubrication unit (plug according to DIN 43650)
Pin Signal
1 Operating voltage +24 V DC
2 Operating voltage 0 V
3 n.c.
PE
WARNING
NOTICE:
B
4
2
3
1
2
3 842 557 976/2020-08, MIT: LU 2/P-24V-3L, Bosch Rexroth AG
Assembly 31/42
C
4
3
1
5
2
557 976-12