Parameterizing The Lubrication Unit For Operation; Re-Commissioning After A Standstill - Bosch Rexroth LU 2/P Montageanleitung

9.1.3

Parameterizing the lubrication unit for operation

Deviating from the factory settings of the lubrication unit, only the parameter
PausedBy must be changed.
For operation on Rexroth TS 2 transfer systemsplus the following parameters are
recommended:
• CYCLE END on Cycle (default)
• LUBE type on 33V/PS (default)
• PauseBy on counter
Default Timer; changeover to start of the lubrication phase by a pulse at the
counter input (see chapter 8.5.9).
• CYCLE Tout on 30s (default)
• LUBE Cycles on 1 (default)
• START IN on RESUME (default)
• PRELUBE on 0 (default)
• DELAY Time on 5s (default)
• SUSPEND on DISABLE (default)
• Pause Cnt on 1 (default)
9.2 Re-commissioning after a standstill
Follow the steps outlined for the initial commissioning.
3 842 557 976/2020-08, MIT: LU 2/P-24V-3L, Bosch Rexroth AG
Commissioning 35/42