Personnel Qualifi Cations; General Safety Instructions; Product-Specifi C Safety Instructions - Bosch Rexroth LU 2/P Montageanleitung

2.4 Personnel qualifi cations
The activities described in this documentation require basic knowledge of
mechanical, electrical, hydraulic and pneumatic systems, as well as knowledge of
the appropriate technical terms. Additional knowledge regarding the use of lifting
gear and corresponding slings is required for transporting and handling the product.
To ensure safe use, these activities should therefore only be performed by qualifi ed
personnel or by an instructed person acting under the direction of such a person.
Qualifi ed personnel refers to those who can recognize potential hazards and
take appropriate safety measures based on their technical training, knowledge,
experience, and understanding of the relevant regulations pertaining to the work
being performed. Qualifi ed personnel must comply with the relevant technical
regulations and have the necessary expertise.
Bosch Rexroth off ers training support for specialized fi elds. You can fi nd an
overview of the training content online at: http://www.boschrexroth.de/didactic

2.5 General safety instructions

• As owner, please note the following: before the initial commissioning of the
product, carry out a risk assessment in accordance with the national regulations in
your country (in Germany: according to the Occupational Health and Safety Act).
• As distributing company/manufacturer of the machine, observe the following:
Before the initial commissioning of a conveyor system, conduct a risk assessment
in accordance with DIN EN ISO 12100.
• Observe the applicable accident prevention and environmental protection
regulations.
• Observe the safety rules and regulations of the country in which the product is
being used.
• Only use Rexroth products that are in proper working order.
• Heed all the notices on the product.
• Persons who assemble, operate, disassemble or maintain Rexroth products should
not be under the infl uence of alcohol, drugs or medication that may aff ect their
ability to respond.
• Use only original accessories and spare parts from Rexroth in order to prevent
hazards to people due to unsuitable spare parts.
• Observe the technical data and ambient conditions specifi ed in the product
documentation.
• Only start up the product if it has been determined that the end product (for
example, a machine or system) into which the Rexroth products have been installed
complies with national provisions, safety regulations and application standards.
2.6 Product-specifi c safety instructions
• Do not attempt to modify the product.
General
• Do not expose the product to any mechanical loads under any circumstances.
Never use the product as a handhold or step. Do not place any objects on the
product.
• Always ensure that the product cannot topple over.
During transport • Observe the transport instructions on the packaging.
• Inspect the product for obvious transport damage.
During assembly
• Route the cables and lines adequately protected to prevent mechanical damage
and ensure that no one can trip over them.
• Make sure the system component you are working on is depressurized and
de-energized before assembling the product or inserting or removing plugs.
• Ensure that the system component cannot be switched back on.
• Before commissioning, make sure that all seals and plugs for the screwed
connections are correctly installed and undamaged to prevent liquids and foreign
bodies from entering the product.
3 842 557 976/2020-08, MIT: LU 2/P-24V-3L, Bosch Rexroth AG
Safety instructions 9/42