Herunterladen Inhalt Inhalt Diese Seite drucken

Personal Protective Equipment; Operator Responsibilities - Bosch Rexroth LU 2/P Montageanleitung

Automatische schmiereinheit
Inhaltsverzeichnis

Werbung

Verfügbare Sprachen
  • DE

Verfügbare Sprachen

  • DEUTSCH, seite 1
10/42
Safety instructions
During commissioning
During operation
EMERGENCY STOP,
malfunction
During servicing and repair
During disposal
Bosch Rexroth AG, MIT: LU 2/P-24V-3L, 3 842 557 976/2020-08
• Allow the product to acclimatize for a few hours prior to commissioning in order to
prevent water condensation from forming in the housing.
• Make sure that all electric, hydraulic and pneumatic connections are either being
used or are covered.
• Check the safety requirements according to DIN EN 619.
• Only commission a product that has been completely installed.
• Make sure that all the safety equipment which forms part of the product is present,
has been properly installed, and is fully functional. Do not move, bypass or disable
any safety equipment.
• Do not reach into moving parts.
• Check the product for malfunctions.
• Make sure that only authorized personnel perform the following tasks within the
scope of the product's intended use:
– starting or operating the system, or interfering with its normal operation.
– Operating component or part adjusters.
• Only allow people to be in the immediate vicinity of the product when it is
operating if they are authorized by the owner to be there. This also applies when
the product is idle.
• Make sure that:
– There are no obstacles preventing access to the EMERGENCY STOP controls.
– All delivery points, workstations and passages are kept clear.
• Do not use EMERGENCY STOP controls for routine stopping.
• Regularly check the EMERGENCY STOP controls to ensure that they are functioning
properly.
• Following an EMERGENCY STOP or in the event of a fault or other irregularity, turn
the product off and secure it against being switched back on.
• Do not reach into moving parts.
• An idle system is not necessarily a safe system, as stored energy can be released
unintentionally or through improper maintenance procedures.
• After an EMERGENCY STOP or a malfunction, only switch the system back on once
you have established and rectifi ed the cause of the fault.
• Make sure that access to maintenance and inspection points is kept unobstructed.
• Perform the prescribed maintenance work at the intervals specifi ed in chapter 10.3
"Maintenance".
• Make sure that no line connectors, connections or components are disconnected
as long as the system is supplied with pressure and voltage. Secure the system
against being switched back on.
• Dispose of the product in accordance with the regulations in your country.

2.7 Personal protective equipment

• Appropriate protective clothing should be worn when handling/using the product
(e.g. safety shoes, close-fi tting clothing, a hair net for long, loose hair).
As the system user or operator, you are personally responsible for ensuring the use
of appropriate protective equipment when the product is being used.
All component parts of the personal protective equipment must be free of damage.

2.8 Operator responsibilities

• Before the initial commissioning or re-commissioning of a conveyor system,
carry out a risk assessment in accordance with DIN EN ISO 12100.
• Before initial commissioning, make sure there are no protruding or sharp-edged
parts that may be a hazard to personnel working or moving in the area.
• Provide safety-related instructions to the operating personnel before initial
commissioning or re-commissioning, and then at regular intervals.

Werbung

Inhaltsverzeichnis
loading

Inhaltsverzeichnis