Electric Pto (Rear); Transport; Loading The Vehicle For Transport - Kärcher MIC D Bedienungsanleitung

6.12 Electric PTO (rear)

7

Transport

7.1

Loading the vehicle for transport

DANGER
Risk of damage!
The vehicle is not approved for crane loading.

Do not use a fork lift, the vehicle could get damaged.

WARNING
Risk of personal injury or damage!
Observe the weight of the vehicle when loading it!

Net weight (without attachments)
* If attachments are installed, the weight is accordingly
higher.
7.1.1 Fastening of the transport restraint on the articulated joint
92
1 Electric PTO
The following table shows the PIN assignment of the elec-
tric PTO rear.
PIN
A
B
C
D
E
F
The operation takes place with the "Electric PTO back"
switch
Push the switch upwards, output 1 is activated.

Push the switch down, output 2 is activated.

6.12.1 Maximum connected load
The maximum connected load of the electric PTO in the
front and back is 20 A together (both PTO are switched
on).
Slowly drive the vehicle onto the transport vehicle.

Note
If the vehicle is not in running condition, observe Chapter
"Towing".
1650 kg*
1 Storage transport restraint
2 Bolt with safety clip
3 Transport lock
Pull out both bolts.

Push the transport restraint out of the storage location.

Secure the transport restraint by means of bolts.

35
-
EN
Name
Ground
+12V from F05
+12V from F05
Output 1
Output 2
Wheel speed signal
Value
20 A from
F05