Fill In Motor Oil - Kärcher MIC D Bedienungsanleitung

10.4.8 Fill in motor oil

10.4.9 Change the motor oil and the oil filter
WARNING
Risk of burns!
To change the motor oil and motor oil filter, allow the

vehicle to cool down until there is no longer a risk of
burns.
Note
A warm motor facilitates the draining of the motor oil.
Prepare a collection container for at least 10 litres of oil.

Switch off engine.

Unscrew oil drain plug.

Remove oil cap.

Drain off oil.

Unscrew the oil filter.

Clean the intake and sealing areas.

10.4.10 Bleed the fuel system
If the tank is empty or if the fuel filter was replaced, the fuel
system must be bleeded.
Check if the fuel tank is filled.

Turn the ignition key to position I (2 - 5 minutes) and

wait until the fuel pump runs clearly quieter.
1 Mounting of the fuel tank
2 Fuel tank
Remove the left lateral motor panel.

Open the screw of the mounting part of the fuel tank

and swivel the fuel tank towards the outside.
1 Oil filler cap
Remove the oil filler cap.

Fill in motor oil.

Oil grade: Refer to chapter "Technical data"
Do not fill oil above the "MAX" marking.

Close oil cap.

Wait at least 5 minutes.

Check engine oil level.

ATTENTION
An oil level that is too high leads to damages of the engine
by overheating. If the oil level exceeds the "MAX" mark, oil
must be drained until the correct oil fill level has been
reached.
Coat the washer of the new oil filter with oil before fitting

it.
Fit in the new oil filter and tighten it by hand.

Screw in the oil drain screw along with the new washer

(torque to 60 Nm).
Fill in motor oil.

Oil grade: Refer to chapter "Technical data"
Close oil cap.

Let the motor run for approx. 30 seconds.

Wait at least 5 minutes.

Check engine oil level.

Check for leaks.

Deliver the old oil to the respective collection centres.

44
-
EN 101