Endress+Hauser iTEMP TMT162 Kurzanleitung Seite 39

iTEMP TMT162
4.2.1 Direct sensor mounting
1
 17 Direct field transmitter mounting on sensor
1 Thermowell
2 Insert
3 Neck tube nipple and adapter
4 Sensor cables
5 Fieldbus cables
6 Fieldbus shielded cable
1. Mount the thermowell and screw down (1). Screw the gauge slide into the thermowell
(2).
2. Fit the necessary neck tube nipples and adapter (3) on the thermowell. Seal the nipple
and adapter thread with silicone tape.
3. Feed the sensor cables (4) through the neck tube, adapter and cable gland of the field
transmitter housing.
4. Mount the fieldbus shielded cable or fieldbus connector (6) on the other cable gland.
5. Guide the fieldbus cables (5) through the cable gland of the fieldbus transmitter housing
into the connection compartment.
6. Seal both cable glands leak-tight as described in the section: Ensuring the degree of
protection. (→  47) Both cable glands must meet explosion protection
requirements.
Endress+Hauser
2 3 4
Installation instructions
5 6
A0024817
39