Yamaha WaveRunner FX160 Wartungshandbuch Seite 344

POWR
CAMSHAFTS
b
Camshaft installation
1. Install:
• Exhaust camshaft sprocket 1
• Intake camshaft sprocket 2
(with the special tool 3)
Universal magneto and rotor
holder:
YU-01235
Rotor holder:
90890-01235
NOTE:
Install the camshaft sprocket with the punch
mark a facing outside.
Camshaft sprocket bolt:
24 N • m (2.4 kgf • m, 17 ft • lb)
2. Install:
• Exhaust camshaft
• Intake camshaft
• Exhaust camshaft caps
• Intake camshaft caps
Installation steps:
• Turn the drive coupling counterclockwise,
and then check if cylinder #1 is at TDC of
the compression stroke with a dial gauge.
• Install the timing chain onto both cam-
shaft sprockets, and then install the cam-
shaft.
CAUTION:
Do not turn the crankshaft when install-
ing the camshaft to avoid damage or
improper valve timing.
NOTE:
• Make sure that the punch marks a on the
camshafts face up.
• Be sure to align the alignment marks b
made during removal to install the timing
chain and camshaft sprockets.
5-59
E