Honda BF40D Bedienungsanleitung Seite 428

11) Remove the 10 mm E-rings from the upper cylinder pin,
and remove the upper cylinder pin.
1
Remove the upper joint metal of the power trim/tilt
assembly from the swivel case assembly.
2
Check the upper cylinder bushings of the power trim/tilt
assembly mounted on the upper joint metal for wear,
3
damage or deformation. Replace the upper cylinder
bushings with new ones if necessary.
4
If the upper cylinder bushings have been removed, replace
them with new ones on reassembly.
5
6
7
8
9
10
11
12
12) Remove the tilting bolt cap.
13
Holding the 7/8-14 UNF self-locking nut on the R. stern
14
bracket side, loosen the 7/8-14 UNF self-locking nut on the
L. stern bracket side.
15
• Loosen the 7/8-14 UNF self-locking nut with care not to
16 remove it from the tilting shaft.
17
18
19
20
14-5
[2] 10 mm E-RING (2)
[1]
UPPER JOINT
METAL
[5]
UPPER CYLINDER
BUSHING (2)
[1]
L. STERN
BRACKET
[3]
7/8-14 UNF SELF-
LOCKING NUT
428
[3]
SWIVEL CASE
ASSEMBLY
[4]
UPPER CYLINDER
PIN
[2]
TILTING BOLT CAP