Honda BF40D Bedienungsanleitung Seite 424

5) Remove the trim angle sensor 3P connector from the
electric part case.
Disconnect the trim angle sensor 3P connector, and release
1
the trim angle sensor wire from the clamps on the electric
part case.
2
6) Pull out the trim angle sensor wire between the electric part
case and the main wire harness while pulling the main wire
3
harness toward you.
4
5
6
7
8
9
10
11
12
7) Loosen the 5 x 10 mm rivet screw and remove the 14 mm
13
clip from the engine under case.
14
Remove the under case grommet C from the engine under
case.
15
Pull out the power tilt motor wire and the trim angle sensor
16 wire through the hole in the engine under case.
17
18
19
20
14-3
[1] ELECTRIC PART
CASE
[1] ENGINE
UNDER CASE
[6]
TRIM ANGLE
SENSOR WIRE
[5]
14 mm CLIP
424
[2] CLAMPS
[3]
TRIM ANGLE
SENSOR
3P CONNECTOR
[2] CLAMPS
[4] MAIN WIRE
HARNESS
[2]
POWER TILT
MOTOR WIRE
[3]
UNDER
CASE
GROMMET C
[4]
5 x 10 mm
RIVET
SCREW