Maintenance; Troubleshooting List - B. Braun Aesculap Acculan 4 GT666 Gebrauchsanweisung/Technische Beschreibung

8.

Maintenance

To ensure reliable operation, the product must be maintained in accor-
dance with the maintenance labeling or at least once a year.
YYYY-MM
For technical service, please contact your national B. Braun/Aesculap
agency, see Technical Service.
9.

Troubleshooting list

►
Have defective products repaired by Aesculap Technical Service, see Technical Service.
Issue Cause
Product not functional No battery
Battery not charged
Battery defective
Product in locked OFF position Safety catch is in OFF position
Product defective
Product becomes too hot Excessive use
Reprocessing/maintenance
carried out incorrectly
Fall damage, product defec-
tive
Blunt tool
Insufficient power Product broken
Blunt tool
Loud running noise Defective product drive/ball
bearings
Lid cannot be Lid not compatible
attached/removed
Lid deformed/defective
Connection to product
deformed/defective
Battery cannot be Battery not compatible
inserted/removed
Battery deformed/broken
Battery shaft to product
deformed/defective
Detection
No battery in the battery compartment Insert battery.
No signal tone when inserting the bat-
tery
No signal tone when inserting the bat-
tery
Product not functional
Product heating
Product becomes hot
Product becomes hot
Heating of tool and product
Inadequate product performance
Steep rise in temperature after a short
period of time
Tool blades worn
Loud, perceptible noise during opera-
tion
Lid does not latch
Lid is difficult or cannot be
mounted/removed
Lid is difficult or cannot be
mounted/removed
Battery cannot be completely inserted
into the battery compartment
Battery is hard or impossible to
insert/remove
Battery is difficult or cannot be
mounted/removed
Remedy
Charge battery in the charger.
Have the manufacturer repair the battery.
Turn the safety catch to the ON position.
Have the manufacturer repair the product.
Observe instructions for use (nominal operating
mode).
Follow operating instructions (preparation, care).
Preventive measure: Oil product before every ster-
ilization.
Have the manufacturer repair the product.
Replace tool.
Follow operating instructions (preparation, care).
Preventive measure: Oil product before every ster-
ilization.
Have the manufacturer repair the product.
Follow operating instructions (operating mode).
Have the manufacturer repair the product
Change tool.
Follow operating instructions (preparation, care).
Preventive measure: Oil product before every ster-
ilization.
Have the manufacturer repair the product
Use lid compatible with GT666.
Have the manufacturer repair the lid.
Have the manufacturer repair the product.
Use battery compatible with GT666.
Have the manufacturer repair the battery.
Have the manufacturer repair the product
en
11