Ryobi RCS3535A Bedienungsanleitung Seite 48

EN
FR DE ES
[Make sure ignition switch
is in the position].
Engine starts but will not
accelerate properly.
Engine starts, then dies.
Engine starts but will not run
properly at high speed.
Engine does not reach full speed
DQGRU HPLWV H[FHVVLYH VPRNH
Engine starts, runs, and
accelerates but will not idle.
&KDLQ WXUQV DW LGOH
IT PT NL SV DA NO
English(original instructions)
1R VSDUN
Engine is flooded.
Carburettor requires
(Low jet) adjustment.
Carburettor requires
adjustment.
/XEULFDQWIXHO PL[WXUH LQFRUUHFW
Air filter dirty.
Spark arrester screen dirty.
Carburettor requires
(High jet) adjustment.
Carburettor requires adjustment
to idle speed.
&DUEXUHWWRU UHTXLUHV DGMXVWPHQW
to idle speed.
Air leak in the intake system.
FI HU CS RU RO PL
earlier in this manual.
plug. Move choke lever to
(pushed in completely) and pull starter cord
 WR  WLPHV 7KLV ZLOO FOHDU H[FHVV IXHO IURP
engine. Clean and reinstall spark plug. Set
ignition switch to
fully release primer bulb 7 times. Pull starter
three times with choke lever at
does not start, move choke lever to
If engine still fails to start, repeat procedure
with a new spark plug.
Contact an authorised service centre for
carburettor adjustment.
/RZ -HW &RQWDFW DQ DXWKRULVHG VHUYLFH FHQWUH IRU
carburettor adjustment.
Contact an authorised service centre for
carburettor adjustment.
Use fresh fuel and the correct 2-cycle
OXEULFDQW PL[ UDWLR
Clean air filter. Refer to
manual.
Clean spark arrestor screen. Refer to
this manual.
Contact an authorized service centre for
carburettor adjustment.
urn idle speed screw
increase idle speed. Refer to
this manual.
7XUQ LGOH VSHHG VFUHZ
to decrease speed. Refer to
his manual.
Contact an authorised service centre for a
rebuild kit.
SL HR ET LT
, remove spark
position. Push and
and repeat normal starting procedure.
in the Maintenance section of this
in the Maintenance section of
clockwise to
in the Maintenance section of
counter clockwise
in the Maintenance section of
LV SK BG
position
If engine