Herunterladen Inhalt Inhalt Diese Seite drucken

Blackmagic Design URSA Mini 4.6K Handbuch Seite 76

Vorschau ausblenden Andere Handbücher für URSA Mini 4.6K:
Inhaltsverzeichnis

Werbung

Verfügbare Sprachen
  • DE

Verfügbare Sprachen

  • DEUTSCH, seite 669
The left edge of the histogram displays shadows, or blacks, and the far right displays highlights,
or whites. When you close or open the lens aperture, you'll notice the information in the
histogram moves to the left or right accordingly. You can use this to check 'clipping' in your
image shadows and highlights. If the left and right of your edges of the histogram come to an
abrupt stop rather than falling off gradually, you may be losing highlight or shadow detail.
NOTE
If you don't see a histogram in the bottom left of your touchscreen, your
LCD monitor settings may be set to display 'codec and resolution.' See the 'monitor
settings' section in this manual for more information.
Record button
Next to the histogram at the bottom of your URSA Mini's touchscreen, you'll see a round grey
button. This is the 'record' button. Tap this once to begin recording, and tap it again to stop. While
recording, the button and the timecode at the top of your URSA Mini touchscreen will turn red.
Your URSA Mini's 'record' button, next to the storage
indicators at the bottom of the LCD touchscreen
The 'record' button turns red when recording
Dropped Frame Indicator
The 'record' button will be overlaid with a flashing '!' indicator if your URSA Mini begins
dropping frames while recording. The time remaining indicator for the affected card or cards will
also turn red. For example, if you are recording in dual card mode and card 1 is dropping frames,
the '!' indicator will appear over the 'record' button, and the time remaining indicator on card 1
will turn red. This lets you know if a particular card is too slow for your currently selected codec
and resolution. The 'dropped frame indicator' will also display if you have dropped a frame on
the previously recorded clip. This indicator will continue to display until another clip is recorded,
or the camera is power cycled. Refer to 'Choosing a CFast 2.0 card' section in this manual, for
more information on how to avoid dropping frames.
Dropped frame indicator for CFast card 1 dropping frames
TIP
If you have the your URSA Mini's door LED enabled, this will rapidly flash red when
dropped frames are detected. For more information, see the 'setup settings' section in
this manual.
Touchscreen Controls
76

Quicklinks ausblenden:

Werbung

Inhaltsverzeichnis
loading

Diese Anleitung auch für:

Ursa mini 4kUrsa mini pro 4.6k

Inhaltsverzeichnis