Rear Panel - Blackmagic Design URSA Mini 4.6K Handbuch

20 HD Monitoring Output
3G-SDI connector for down converted 1080HD output. Use with Blackmagic URSA
Viewfinder or external monitors. Refer to the 'camera video output' and 'Blackmagic
URSA Viewfinder' sections for more information.
21 +12V Power Output
4 pin XLR connector for powering Blackmagic URSA Viewfinder, Blackmagic URSA Studio
Viewfinder or external monitors and accessories. Refer to the 'Blackmagic URSA
Viewfinder' and 'Blackmagic URSA Studio Viewfinder' sections for more information.
22 LANC Input
Dedicated 2.5mm TRS LANC connector for Blackmagic URSA Mini side handle.
Refer to the 'getting started' section for more information on connecting
the side handle.
23 Broadcast Lens Control Connector
Provides power and control to compatible PL and B4 mount lenses with 12 pin connections.
This connection is available on URSA Mini PL and URSA Mini Pro 4.6K models.

Rear Panel

24 Battery Mount Plate
Your Blackmagic URSA Mini has 4 mounting points and a molex connector behind
a small cover for attaching the optional V mount or gold mount battery plate.
Refer to the 'mounting batteries' section for more information.
25 LANC
This 2.5mm jack is used for external LANC remote control, such as an external record
start stop control mounted to a tripod arm. LANC supports record start and stop, plus
iris and focus control using compatible EF lenses.
24
26 12G-SDI Out
Blackmagic URSA Mini's 12G-SDI output is used to send HD and Ultra HD video
to SDI equipment such as routers, monitors, SDI capture devices, and broadcast
switchers. You can also connect the 12G-SDI output to an external recorder such as
the Blackmagic Video Assist for backup recording.
25
26
27
28
29
30
Introduction to URSA Mini 43