Blackmagic Design URSA Mini 4.6K Handbuch Seite 127

To attach the top handle with URSA Viewfinder
1
Top handle
Place your URSA Mini on a flat, stable surface
so you can access the top of your camera.
3
URSA Viewfinder adapter plate
Fasten the URSA Viewfinder adapter plate to the
handle using the 4 x M3 screws with a 2.5mm Hex
key driver.
URSA Viewfinder cap
2
Remove the URSA Viewfinder cap from the
base of the handle by gently lifting its arm
away from the side of the handle and pulling
the cap from the hole.
4
2 x 1/4" socket head
screws for mounting
handle to camera
Fasten the handle to any two of URSA Mini's top
1/4" mounting points using the two supplied 1/4"
screws with a 3/16" Hex key driver. URSA Mini's
rear two mounting points are recommended for
most situations, but you can choose any pair for
better weight balance when using large lenses.
Avoid over-tightening the screws as it may
damage the screw threads.
The hole inside the front of the handle is used
with the thumb screw when attaching and
adjusting the URSA viewfinder. For information on
how to attach the URSA Viewfinder to the top
handle, refer to the 'Blackmagic URSA Viewfinder'
section in your URSA manual.
URSA Mini Shoulder Mount Kit
Thumbscrew for adjusting
the optional URSA
Viewfinder position
127