Blackmagic Design URSA Mini 4.6K Handbuch Seite 151

Attaching the PL Mount
1
4.6K
SDI OUT
LENS
Gently insert the PL baffle into the center of the
lens mount and turn until it is finger tight. Use the
wide end of the baffle tool to tighten the baffle
slightly. You need just enough pressure to keep
it in place.
3
4.6K
SDI OUT
LENS
Loosely turn the five mounting screws until initial
contact is made with the shoulder of the lens
mount. To access all five screws, you will need to
rotate the PL locking ring, as some holes are
obscured when the ring is either open or closed.
NOTE When removing the PL mount, simply follow the instructions in reverse order
from step 4 to step 1. Don't forget to remove the PL baffle and store it securely with
the PL mount.
2
SDI OUT
ND
FILTER
AUTO
W/B
LENS
Add the 0.10mm shim to your camera, then place
the Blackmagic URSA Mini Pro 4.6K PL lens mount
onto the camera body. Ensure the pins on the PL
mount for Cooke /i Technology are located at the
12 o'clock position.
4
SDI OUT
ND
FILTER
AUTO
W/B
LENS
Using the 2mm Hex driver, or torque wrench with
2mm Hex key, apply one full turn of pressure to
mounting screw 1, followed by one full turn to
screw 2. Repeat for screws 3 and 4, then 5.
Continue to apply one full turn to each screw in
the sequence above until all screws have reached
the maximum torque of 0.45Nm.
4.6K
ND
FILTER
AUTO
W/B
4.6K
1
3
ND
FILTER
4
2
AUTO
W/B
5
Interchangeable Lens Mount 151