Indicator lights
ON/OFF button light
• Slowly flashing orange handpiece battery has low power and must be exchanged soon
• Fast flashing orange handpiece battery is empty and must be exchanged to continue
to operate
• Solid orange unit is in an overheating protection state and can't be operated until light
turns off .
Light adjacent charging port (
• Solid orange battery is charging
• Solid green battery is fully charged .
Audible signals
• One short beep: battery or attachment insertion into handpiece
• One beep: start of cycle, interrupt, every 30 seconds of usage, or end of cycle
• Two beeps: warning (i . e . attachment is not connected)
• Four beeps: overheating protection .
Signal Condition
Battery Insertion
Start Cycle
Second power level
Stop cycle manually
End of cycle
Warnings (i . e . attachment not connected)
Low battery
Empty battery
Overheating protection
3.1 Installation and charging
1 . Insert battery pack into handpiece . Battery pack is pre-charged however, it may be
necessary to charge the battery before first use .
2 . To recharge the battery:
• Connect charging base to USB mini connector .
• Make sure power socket used for power connector is accessible at all times in case of
necessary emergency disconnection .
• Insert the battery onto the charging base . The battery light will illuminate solid orange,
indicating battery is recharging and will show constant green when fully charged .
Note, the SmartLite Pro EndoActivator™ Complete Kit comes with two batteries . It is
recommended that the battery not being used is stored on the charging base so that it is fully
charged when needed .
3.2 Operation – EndoActivator Attachment Assembly
1 . Attach the EndoActivator Attachment to the SmartLite Pro® handpiece by firmly pressing
attachment into handpiece opening while slightly rotating at the same moment .
2 . Protect assembled handpiece and attachment from gross debris by applying a single-use
barrier sleeve .
NOTE: no light with battery on top indicates missing contact
EndoActivator Attachment
Beep
2x
4x
Signal LED
1x
-
1x
-
1x
-
1x
-
1x
-
-
-
blinking
-
blinking fast
continuous
)
9