Inhaltsverzeichnis
Werbung
Safety Program Creation - Configuration Example
The F_Dest_Add entry and the setting of the address switches for the measuring
system must correspond!
The parameter value for the parameter F_iPar_CRC results from the set parameter
data set for the iParameters and the calculated CRC value. See chap.: 4.3.1 "Setting
the iParameters" on page 102.
The blocks for the safety program are generated automatically. The only
precondition is that the F-CPU has activated the fail-safe. (See chap.: 4.2.1
"Defining the properties of the hardware configuration" on page 95).
TR-Electronic GmbH 2019, All Rights Reserved
Page 104 of 144
TR - ECE - TI - DGB - 0340 - 01
Printed in the Federal Republic of Germany
12/17/2020
Werbung
Inhaltsverzeichnis
