Setting The F-Parameters - TR-Electronic CD 75 Serie Gesamt-Bedienungsanleitung

Safety Program Creation - Configuration Example

The properties of the slot are displayed in the Device view in the inspector
window after selecting Properties -> General.
To set the iParameters, the Module parameters directory must be selected in
the directory tree of the General tab.
If different parameter values are required, as shown above, a F_iPar_CRC
calculation must occur for this new parameter data set. See chap.: 3 "Parameter
definition / CRC calculation" on page 89. The calculated value must then be entered in
the parameter data set of the F-parameters under F_iPar_CRC. See chap.: 4.3.2
"Setting the F-Parameters" on page 110.

4.3.2 Setting the F-Parameters


In order to set the F-Parameters, first go to the Device view of the work area
and in the Device overview tab displayed on the right-hand side select the
entry CD_75_-EPN E/A safety_1 with the left mouse button.
 TR-Electronic GmbH 2016, All Rights Reserved
Page 110 of 159 TR-ECE-TI-DGB-0292 v02
Printed in the Federal Republic of Germany
08/06/2021