TR-Electronic CD 75 Serie Gesamt-Bedienungsanleitung Seite 156


Set the device name by DCP:
-
-
-
In the delivery state as well as after a system boot up the measuring system has not
saved a device name.
Printed in the Federal Republic of Germany
07/15/2015
Open the menu "PLC --> Ethernet --> Assign device name" in the
"HW Config" window.
The supplyed measuring systen that is connected to the Network should be
visible in the list after pressing the "Update" button.
A few seconds after pressing the button "Assign name" the list refreshes
automatically and the new device name is taken over.
TR - ECE - TI - DGB - 0233 - 03
 TR-Electronic GmbH 2013, All Rights Reserved
Page 61 of 79