Care And Maintenance - Westfalia 24 15 88 Bedienungsanleitung

Removing jammed staples/nails
Unplug the tool from mains supply before working on the tool itself!
- Press the locking lever down and slide the feeder backwards out of the tool.
- Remove jammed parts careful with a slim plier or tweezer.
- Load new staples/nails if needed.
- Slide the feeder in till he stops. Ensure locking lever is fully engaged (see Picture on page 6
above at left)

Care and Maintenance

Unplug the tool from mains supply before working on the tool itself!
- Clean the tool after every using by using a damp cloth.
- Do never use petrol, turpentine, thinner or similar products. The can destroy the plastic
parts.
- Pay attention, that no liquids comes into the housing. Do not dip the tool into liquids.
- Pay attention, that the ventilation gaps are open and clean.
- Pay attention to tight fit of screws and all parts of the tool.
- Do not open the tool, take it to an autorized service (electrician) or our service.
15