Westfalia 24 15 88 Bedienungsanleitung Seite 15

Nail strip,
points facing
upwards
Operation:
- Plug the tool to the mains supply.
- Slide the switch lock (2) to the left.
- Set the tool with both hands (one hand on the motor-head) to the working piece and push it
down, till you hear a click from the trigger contact. Use both hands, otherwise the tool can
jump - injury and unproper works are following.
- Now press the On-/Off switch one time. The tool shots the staple or nail.
The tool endues to a locking feature to avoid unintentional initiating. You can only shot, when
the tool is safely pressured onto the working piece (you can hear a click). But now you can
shot.
- The impact force can be adjusted by the impact force regulator (4) according to the working
piece material. Its recommend to test the impact force and the stapling quality on a nonseen
place of the working piece.
- After finishing the work slide the switch lock (2) to the right and unplug the tool from mains
supply.
Note!
The tool gets hot during the work. This is normal and not an error. Pay attention to the maximum
number of shots per minute (20/min).
Check during work periodically the fastened seat of the feeder!
Check the stock of staples/nails
- In the control window (1) you can check the consumption of staples/nails. Is the feeder to see
in the window, loading of new staples/nails is needed.
14