Recommendations For Soldering Work - Faller 163701 Bedienungsanleitung

Equipping the workplace environment
- Spiral wool, small sponges or cloth to wipe off excess soldering tin.
- Unsoldering stranded wire in case of erroneous soldering.
- Hot-melt glue, scale modelling glue "Uhu por" or double-sided adhe-
sive tape, to secure the batteries again in bus models after soldering.

Recommendations for soldering work

Tips for the unsoldering of wired components and the right soldering of
the conversion PCB.
DANGER
Risk of severe burns and intoxications
Working with a soldering iron und soldering tin involves a considerable
risk of burns and intoxications.
EN
Observe the recommendations of the manufacturer of the solde-
X
ring iron or soldering station. Hold the soldering iron only with the
handle provided for that purpose. Never touch a hot soldering iron
or molten soldering tin.
When soldering always provide for adequate ventilation of the
X
workplace environment as soldering generates toxic vapours that
may not be breathed in.
Soldering tin may not come in contact with the mouth or be swal-
X
lowed as the metals it contains can have harmful effects.
NOTE:
Avoid any dirt and fingerprints on the conversion PCB.
ƒ
If you are not or not enough familiarized with soldering work, first carry
ƒ
out some tests on an old PCB.
ƒ Make sure you work on a flat and clean soldering mat.
Provide for adequately good lighting at your workplace, for instance by
ƒ
using a magnifying glass fitted with a lamp.
Earthing/Conductive discharge: Use an ESD protective mat to lead away
ƒ
the electrostatic charges.
92