Faller 163701 Bedienungsanleitung Seite 124

Converting the vehicle
Fig. 46: Passage in dry-reed sensor
EN
Fig. 47: Checking the dry-reed sensor
Step 4: Soldering the dry-reed sensor
Solder the dry-reed sensor in accordance with the inscription on the
X
PCB.
- 00 GND
- 06 Dry-reed sensor
Step 5: Soldering the ultrasonic capsule
Solder the ultrasonic capsule in accordance with the inscription on the
X
PCB.
- 07 Ultrasonic capsule
- 08 Ultrasonic capsule
Step 6: Soldering the motor
NOTE: Please also pay attention to the information relating to the PCB pad
assignments for connecting the motor given in the Chapter
ment on conversion PCB".
124
"Pad assign-