Faller 163701 Bedienungsanleitung Seite 87

No. Component
10
Motor
11 Rechargeable battery "-" (minus)
12
Rechargeable battery "+" (plus)
13 Temperature sensor
Table 2: Contact assignment Conversion PCB, underside
NOTE on contact GND: GND/Ground can be found in several places on the
PCB that are meant to be used at will.
Simply choose a soldering pad that is near the relevant connection.
X
NOTE on contacts 09 and 10 intended for the motor:
Depending on the position of the motor the following pad assignments
can be defined:
- Motor standing before the rear axle: red "+" (plus) cable to 09
- Motor standing behind the rear axle: red "+" (plus) cable to 10
- Motor lying behind the rear axle: red "+" (plus) cable to 09
- Motor lying before the rear axle: red "+" (plus) cable to 10
On motors without built-in cable the "+" (plus) connection is either marked
with a small "+" or with a colour point.
NOTE: Please bear in mind that the aerial of the conversion PCB may not
under any circumstances be prolonged or shortened.
General view of product
EN
87