RTW SurroundControl 31960 Serie Bedienungsanleitung Seite 261

6. Connect the unit to power supply and power it on.
Press the Menu button. The menu system is initialized.
7.
Use the < or > button to select the gPiO configurati-
8.
on menu tab. The global gPiO settings menu page is
displayed.
Use Ù or Ú button to set the focus to the Function com-
9.
bo boxes of the Outputs you have to change. Confirm
with red sel (SELECT) key.
10. Use Ù or Ú button to set the focus on the function option
you need (Key Preset or alarm). Enter the selection by
pressing the red sel (SELECT) key.
11. Repeat steps 7 and 8 for the other output functions you
have to change.
12. Use Ù or Ú buttons/keys to select the Output signal ti-
ming combo boxes and the Output logic combo boxes.
Confirm by pressing the red sel (SELECT) key. Proceed
as described in steps 7 to 9.
13. If you have assigned the alarm function to outputs, use <
or > key to select the Alarm Configuration menu tab. The
Global Alarm Setting menu page is displayed.
14. Use Ù or Ú buttons/keys to set the focus to the on
checkbox of the alarm general settings frame. Enter
the selection by pressing the red sel (SELECT) key.
15. Use Ù or Ú buttons/keys and the red sel (SELECT) key
to select other options you need to change.
16. In the Alarm-Event Type Selection section, only the Out-
put combo boxes which have been assigned with the alarm
function (as described before, steps 7 to 8) are available.
17. Use Ù or Ú key to set the focus to one of the combo
boxes. Confirm by pressing the red sel (SELECT) key.
SurroundControl 31900/31960 Series
18. Use Ù or Ú key to select the option you need. Confirm by
pressing the red sel (SELECT) key.
19. Use < or > key to select the instrument settings menu
tab. The instrument settings menu page is displayed.
20. Use Ù or Ú key to set the focus to the edit selected
preset button. Confirm by pressing the red sel (SELECT)
key.
21. Use < or > key to select the local input/Output
routing and instrument settings menu tab. The local
routing settings menu page is displayed.
22. Use Ù or Ú key to set the focus to the Monitoring input
routing button. Confirm by pressing the red sel (SE-
LECT) key.
23. On the Key 1 to Key 7 menu pages, use the Ù or Ú
button to select one or more of the check boxes labelled
gPiO 1 to 8 depending on your definition of the output
switching state for this key. The check boxes of the out-
puts set to the alarm functions are greyed and cannot be
selected.
24. Click the save & exit button or press the corresponding
key to store the changes and leave the menu. The save
Preset menu page is displayed.
25. Press the red sel (SELECT) key, if you want to select
another User Preset as the displayed one. Use the Ù or
Ú button to set the menu focus to the one you prefer and
press the red sel (SELECT) key.
26. If you want you can change the name of the preset. The
button change name opens a keyboard to enter the
name you prefer (6 characters).
27. Click the save & exit button again to store the changes
and leave the menu. The unit returns to normal operation.
7 | Control | 7.3 | External control via GP IO connector
EN
EN-49