Switching Input Sources By Using Sub Presets - RTW SurroundControl 31960 Serie Bedienungsanleitung

6.5 | Switching Input Sources by using Sub Presets
to switch between the (up to) 7 sub Presets available in
a Factory or User Preset, please proceed as follows:
Press the input key. The corresponding Input button in
1.
the Toolbar is located above the MOde and the MOre
button and always shows the currently loaded Sub Preset.
The input key on the Remote Control 30050 lights
up. Now the names of the 7 Sub Presets and the input
connector they use are shown in the buttons 1 to 7 of the
Toolbar.
SurroundControl 31900/31960 Series
input Used input
button connectors
Toolbar Name of the
(Window 1) Sub Presets
2. Select the Sub Preset of your choice by pressing one of
the numbered keys 1 to 7. The new Sub Preset will be
loaded instantly. The unit will use the input signals fed to
the connector defined in the Sub Preset.
nOte - In case the routing settings of the selected
Sub Preset do not fit your connecting scheme you will have
to adapt the routing setup of the preset. Please refer to para-
graph adapting the routing for more details about this.
6 | First Use | 6.5 | Switching Input Sources by using Sub Presets
EN
EN-23