Positioning Or Stowing The Foot Supports - Not Available With Prime X Option - Stryker Prime Serie Bedienungsanleitung

Attaching the IV caddy (Continued)
7. Close the clamp (C) around the IV pole and pivot the knob (A) into position.
8. Turn the knob (A) clockwise to tighten the knob.
9. Reverse steps to disconnect the IV caddy from the product.
To store the IV caddy, place the IV caddy in the storage tray or secure the caddy in the storage clip.

Positioning or stowing the foot supports - not available with Prime X option

WARNING
• Do not sit on the foot supports. This may cause the product to tip.
• Always clear your fingers from the mechanisms when you operate the foot supports.
• Always stow the foot supports when you transport a patient with the product.
• Always tighten the foot supports before you use the foot supports.
• Do not operate the scale system with the foot supports. Inaccurate readings may occur.
• Do not operate the Chaperone option with the foot supports. Inaccurate readings may occur.
To position or stow the foot supports:
1. Loosen the knee knob (A) at the top of the foot supports to adjust the side-to-side angle of the foot supports
1-17 on page 1-44).
2. Tighten the knee knob (A) to lock the foot supports in the desired position.
www.stryker.com
Accessories
C
B
Figure 1-16: IV caddy
1125-309-005 REV A
A
English
EN
(Figure
1-43