Jungheinrich EFG 113 Betriebsanleitung Seite 83

Positioning the integrated sideshift (option)
Requirements
– Truck prepared for operation, (see "Preparing
the truck for operation" on page 68).
Procedure
• Pull the SOLO-PILOT lever (109) in direction
R to move the load handler to the right (from
the driver's viewpoint).
• Push the SOLO-PILOT lever (109) in direction
V to move the load handler to the left (from the driver's viewpoint).
The sideshifter is now positioned.
Z
When the limit position for the operation has been reached (there will be a noise
from the pressure relief valve) release the lever. The lever will revert automatically
to neutral.
Positioning the forks with an integrated fork
positioner (option)
CAUTION!
Do not use the fork positioner to clamp
loads.
Requirements
– Truck prepared for operation, (see "Preparing
the truck for operation" on page 68).
Procedure
• Press the toggle switch (110) and at the same time pull the SOLO-PILOT (107) in
direction Z: the forks will move towards each other.
• Press the toggle switch (110) and at the same time push the SOLO-PILOT (107) in
direction A: the forks will spread apart.
The forks are now positioned.
Synchronising the alignment of the fork tines
with an integrated fork positioner (optional
equipment)
Requirements
– Truck prepared for operation, (see "Preparing
the truck for operation" on page 68).
– The fork tines are no longer aligned.
82
109
V
R
V
110
R
107
V
110
R
107