Using The Truck For The First Time - Jungheinrich EFG 113 Betriebsanleitung

4

Using the Truck for the First Time

Safety Instructions for Assembly and Commissioning
WARNING!
Accident risk from incorrect assembly
The assembly of the truck at the application site, commissioning and driver training
must only be performed by the manufacturer's customer service representatives who
have been specially trained for these tasks.
The hydraulic lines may only be connected to the basic truck / mast interface when
the mast has been properly assembled.
Only then can the truck be started.
If several trucks have been delivered, make sure that the serial numbers of the load
handlers, masts and basic trucks always match.
CAUTION!
Only operate the truck with battery current. Rectified AC current will damage the
electronic components. Cable connections to the battery (tow leads) must be less
than 6 m long and have a minimum cross-section of 6 yd² (50 mm²).
Preparing the truck for operation after delivery or transport
Procedure
• Check the equipment is complete.
• Check the hydraulic oil level, (see "Hydraulic system" on page 138).
• Install the battery if necessary, (see "Battery removal and installation" on page 44).
• Charge the battery, (see "Charging the battery" on page 43).
The truck can now be started, (see "Starting up the truck" on page 58).
Z
To operate the truck without its own drive system, (see "Operating the truck without
its own drive system" on page 108).
36