Drive Control - Jungheinrich EFG 213 Betriebsanleitung

6.2.2 Drive Control

This option restricts the travel speed of the truck irrespective of the steer angle. From
a factory-set lift height the maximum travel speed is reduced to walking pace (approx.
3 km/h) and the slow travel indicator is activated. When the forks fall below this height,
the truck accelerates at reduced levels to the speed prescribed by the accelerator
pedal to prevent sudden acceleration when changing from slow travel to normal
travel. Normal acceleration is only activated again when the speed prescribed by the
accelerator pedal has been reached.
Z
In addition to the daily checks before starting, (see "Checks and operations to be
performed before starting daily operation" on page 87) the driver must carry out the
following checks:
– Lift the empty load handler beyond the reference lift height and check if the slow
travel display lights up.
– Steering at idle: check if the steering wheel display is working.
6.2.3 Lift Control
This option includes Drive Control and also monitors and controls the mast functions:
Tilt speed reduction as a function of the lift height (from approx. 1,5 m lift height).
– If the load handler is lowered below the limit height, the tilt speed increases up to
the level specified by the control lever.
Optional:
– Tilt angle display.
– Sideshifter zero position: Pressing the sideshift centre position switch ((see "Side
compartment control panel switch (o)" on page 83)) moves the sideshifter
automatically to the centre position.
In addition to the daily checks before starting, the driver must carry out the
following checks:
Procedure
• Lift the empty load handler beyond the reference lift height and check if the slow
travel display lights up and the tilt speed is clearly reduced.
• Steering at idle: check if the steering wheel display is working.
• Check the tilt angle display by tilting forward and back.
133