Parker AC30E Produkthandbuch Seite 480

D-194
Parameter Reference
System Board Option
Parameters::System Board::System Board Option
Parameter Name No.
1739
System Board Required
Identifies whether the system board is required by the configuration.
1740
System Board Fitted
Indicates whether the system board is attached. The system board is a factory fit option.
1741
System Board Status
Indicates the health of the system board, if attached.
Functional Description
These parameters are used to set and verify the System Board Option configuration. If the status parameter is not OK then the drive will not enter
the Operational state.
Status Description
OK The configuration is valid. The status will always be OK if no System Board option is required, even if one is fitted.
OPTION NOT FITTED An option was required and none was detected
TYPE MISMATCH The fitted option does not support the required features
TYPE UNKNOWN The firmware in the drive does not recognise the fitted option
HARDWARE FAULT The fitted option is not working as expected.
Path
Setup::Inputs and Outputs::System Board
Option
Parameters::System Board::System Board
Option
Parameters::System Board::System
Board Option
Parameters::System Board::System
Board Option
Default Range
0:NONE
1:DUAL ENCODER
Same as PNO 1739
0:OK
1:OPTION NOT FITTED
2:TYPE MISMATCH
3:TYPE UNKNOWN
4:HARDWARE FAULT
Units Writable
CONFIG
NEVER
NEVER
AC30 series Variable Speed Drive