Yamaha YZ250F Fahrer- Und Wartungshandbuch Seite 502

È
É
FRONT BRAKE AND REAR BRAKE
5 - 24
2. Install:
• Brake hose holder 1
• Screw (brake hose holder) 2
1 Nm (0.1 m · kg, 0.7 ft · lb)
CAUTION:
After installing the brake hose holders,
make sure the brake hose does not contact
the spring (rear shock absorber). If it does,
correct its twist.
Brake fluid
1. Fill:
• Brake fluid
Until the fluid level reaches "LOWER"
level line a.
Recommended brake fluid:
DOT #4
WARNING
• Use only the designated quality brake
fluid:
otherwise, the rubber seals may deterio-
rate, causing leakage and poor brake per-
formance.
• Refill with the same type of brake fluid;
mixing fluids may result in a harmful
chemical reaction and lead to poor perfor-
mance.
• Be careful that water does not enter the
master cylinder when refilling. Water will
significantly lower the boiling point of the
fluid and may result in vapor lock.
CAUTION:
Brake fluid may erode painted surfaces or
plastic parts. Always clean up spilled fluid
immediately.
È
Front
É
Rear
CHAS