Werbung
SUMMARY
4. pressing the rotation pedal, place the valve at approximately 3 o'clock (see Fig. 130). Using the appropriate push button (Fig. 5 ref. H), place the toolhead
on the edge of the rim;
5. acting on the appropriate button (Fig. 5 ref. F2), use the upper bead breaker roller to push the tyre bead under the rim edge (Fig. 130);
6. insert the bead puller exactly next to the valve (see Fig. 131). Fit the bead protector on the edge of the rim in correspondence with the puller, as shown
in Fig. 132;
To avoid damaging the TPMS valve, it is important that the distance between the traction point (contact point of the tyre bead on the rim) and
the valve is always between 10 cm (3.94") and 15 cm (5.91") before of the valve. To always obtain this result, always insert the bead puller
in correspondence with the valve.
EN_84
7105-M019-00
Fig. 131
KENDO - KENDO.EVO
Fig. 130
Fig. 132
Werbung
